Once silage is in a bunker or pile, the usual question is how many tons you have. You rarely have a scale under the pack, so extension services estimate volume, assume a packing density, and convert to wet tons from the dry-matter content.

The Nebraska method

University of Nebraska CropWatch (Dorn, 2012) starts from a well-packed density of 14 lb of dry matter per cubic foot, a threshold also used by Wisconsin and Cornell. At 35% dry matter (65% moisture), the wet density is 14 ÷ 0.35 = 40 lb per cubic foot.

wet tons = length × width × average depth × 40 ÷ 2,000

Their example is a 50 × 30 × 12 ft bunker: 18,000 cubic feet × 40 lb = 720,000 lb, or 360 wet tons. If you measured a different dry matter or density, replace 40 with (DM density ÷ dry-matter fraction).

Measuring the bunker

Use the average depth, not the peak of a crown. Width is the inside width of the walls, or the average of the top and bottom if the walls slope. For a drive-over pile, treat the cross-section as a triangle or trapezoid and add the end ramps if you want them in the total. The tonnage calculator does both.

Iowa State's depth formula

Iowa State C6-82 estimates dry-matter density from depth: 7.5 + 0.4 × depth (feet) for corn silage, in pounds per cubic foot. A 12-foot pack is 12.3 lb DM/ft³, a little under the 14 lb target. Use it when you do not have a measured pack and the bunker is shallow or loosely packed. The publication's label “tons of dry matter per cubic foot” does not match its own short-form equations; those equations only work if the figure is pounds, which is what we use.